Products by Category:

Tank Linings, Secondary Containment

Dura-Plate UHS Epoxy

DURA-PLATE UHS is an ultra high solids epoxy amine engineered specifically for immersion service in ballast tanks, oil tanks, and refined fuel storage tanks. The high build, edge-retentive properties of Dura-Plate UHS provide superior protection compared to conventional epoxies.

  • Airless Spray
  • One coat protection
  • Low VOC
  • Low odor
  • High flash point, >200°F
  • Can be used with 1.5 oz. fiberglass mat
  • Low Temperature Hardener available for applications from 40°F (minimum) to 77°F (maximum)
  • NSF approved to Standard 61 for potable water (tanks of 1000

gallons or greater and pipes of 40" diameter or greater).

Recommended Usage

For use over prepared steel or concrete surfaces in industrial and marine exposures such as:

  • Meets Mil-PRF-23236C, Type VII, Class 5, 7, Grade C
  • Ballast tank interiors, Oil storage tank interiors, Refined fuel storage tank and potable water tanks interiors and pipe.
  • May be applied up to 50.0-60.0 mils dft in one coat if required
  • Water and waste treatment plants
  • Primary and secondary containment areas
  • Where edge protection film build properties are required
  • Suitable for use with cathodic protection systems
  • Conforms to AWWA D102, ICS #1, ICS #2, ICS #5, OCS #5
  • White B62W211 Contains OAP fluorescent pigment (NSF Approved)
Product Number Product Name GHS SDS Data Page
B62W210 White Part A GHS SDS  |  Data Page
B62W211 White (with OAP additive) NSF Part A GHS SDS  |  Data Page
B62V210 Hardener Clear Part B GHS SDS  |  Data Page
B62V211 Low Temp Hard Clear Part B GHS SDS  |  Data Page
B62G210 Green Hardener Part B GHS SDS  |  Data Page
B62AV210 Light Gray Hardener Part B GHS SDS  |  Data Page